Creating the Right Environment for Your AnaJet mPower Printer
Dean Armando
In this post, we'll guide you through the key steps to create an optimal environment for your AnaJet mPower printer. Whether you're a seasoned user or just starting out, setting up the right conditions is crucial for achieving top-notch printing results.
Anajet mPower Garment Printer Daily Maintenance Guide
customer
Ensuring your printer stays in top condition is crucial for maintaining consistent, high-quality prints. By following a few straightforward steps, you can guarantee that your printer operates at peak condition.
AnaRIP 4.0 RIP Software Installation Guide
customer
Welcome to our AnaRIP 4.0 installation guide! Whether you're a pro or just diving into it, our video will help you breeze through the setup.
Weekly Maintenance on the Anajet mPower Printer
customer
CLEANING SOLUTION LINT FREE WIPES SWABS MPOWER PARTS
Anjanet mPower Ink Dripping from Print Head
customer
Symptoms: Nozzle check pattern has large gaps Drops of ink appear on shirt when printing Visible dripping from print head plate Possible Causes: The print head surface may be dirty. Perform a print head clean 1 from the main menu followed by a nozzle check. Print head plates need to...
Adjusting or Repairing the Sprint Paper Sensor
customer
Symptoms: Printer is looping in Auto System Maintenance. Printer stuck in reset service counter (only in more severe cases), other symptoms will include print head moving to the left before print and getting stuck. Possible causes: Ink will leak down into where the carriage is located and will stain and cause errors...
Activating EK Print Studio
customer
A valid software license file is needed to run the EKPrint Studio for SPRINT program. Without a valid license file, EKPrint Studio for SPRINT will run under evaluation mode for 30 days. After the 30 day evaluation period, the print capability of EKPrint Studio for the printer will be disabled....
How and Where to Set the Ink Color Order on Anajet Sprint
customer
There are many different ways to set up the color going from your ink bay to your print head. Above you will see the tab where you change it in your program. However, in that program gives you an idea of the different configurations. Best option is the way the...
DTG Kiosk Fitting the Gap Sensor
Dean Armando
Click here to download the procedure for fitting the Gap Sensor
DTG Kiosk Preparing for an Extended Shutdown
customer
Transporting or Storing Your Printer It is extremely important you observe the following before transporting or an extended shutdown of your DTG Kiosk. Preparing the Printer for Transportation If the printer is to be transported over a long distance, and/or by a common carrier (where you cannot control the "care"...
DTG Kiosk Installing the WIMS Ancillary Board
customer
To learn how to install WIMS to Kiosk, click here. KIOSK PARTS HM1 PARTS INK
Diagnosing a Clog in the DTG HM1
Dean Armando
What I normally do is to try to isolate the issue from several possibilities to one. The only way to do that is to swap the cartridges. Follow these instructions to see if it is the damper or the print-head. (1) Perform a nozzle check, and note the bad nozzle...
