Support Articles

There is a "NAME PLATE" on every machine, which lists the model name, serial number, and power specifications. On single heads, it is located just underneath the table top fastened to the metal frame. On multi-headed machines, it is located on the metal frame near the center of the machine,...

Your machine is installed with a time clock that prompts you to call and get a password to disable the clock after a certain time period. The message you see is a warning letting you know the time clock is about to expire. Once the time clock expires, you will...

The information in this article applies to the following product: Barudan BEDT-ZQ-501 Elite Pro single head embroidery machine SUMMARY This document shows the locations and service intervals for lubricating the BEDT-ZQ-501 "Elite Pro" machine. This information has been updated since the first machine shipments.   BEDT-ZQ-501 (Elite Pro) LUBRICATION CHART...

What is wrong? What should I do? (BEAT 900 series only) Typically this can be corrected by a simple "System Reset" To do a "System Reset": Power off your machine, power back on, tap the Scroll Lock key until the Scroll Lock light comes on. The machine will boot up...

The information in this article applies to the following machine models:   Barudan N Series Multihead Embroidery machines: BENS, BENY, BENR, BENB Barudan BENT/ ELITE Single Head Embroidery machines   SUMMARY Improper needle depth can cause a variety of sewing problems. This procedure details how to check if the needle...

Thread break detection is done by the check spring. If the check spring is sitting against its post, then the machine assumes the thread is broken. If the machine consistently is not recognizing thread breaks on a particular needle, look at the check spring area. Be sure the spring can...

It is recommended that you shut your machine off at the breaker if it is not going to be in use for an extended period of time to protect it from extreme electrical influences such as lightning.  

To adjust the check spring, use a slotted screwdriver. Put the screwdriver into the end of the lower (or rotary) tension post. Turn the screwdriver counterclockwise until the check spring moves off its post. Then, turn the post clockwise until the check spring touches the post then approximately 1/4 turn...

Learn how to replace the reciprocator on the Tajima Neo Embroidery machine.  

Learn how to replace the presser foot on the Tajima Neo Embroidery machine.  

Learn how to replace the needle bar on the Tajima Neo Embroidery machine. 

 Learn how to preventive maintenance on the Tajima Neo Embroidery machine

Learn how to adjust the cap frame driver on the Tajima Neo Embroidery machine.  

Learn how to set the needle depth and height on your Tajima Neo Embroidery machine. 

Learn how to use the design divide function on the SWF embroidery machine in this video tutorial. Discover the benefits of dividing your designs and find out how to easily divide your designs using the design divide function on the control panel. This video is perfect for anyone who wants...

Learn how to maximize your embroidery capabilities with the SWF embroidery machine's external input function in this tutorial video. Discover the many benefits of this function and how to easily integrate it into your embroidery process. Improve your productivity and take your designs to the next level with the SWF...